Service And Support - PCTV Dual Sat PCI 4000i Guia De Inicio Rapido

Example illustrations can be found on the first page.*
1. PCTV Dual Sat PCI (4000i)
2. Installation-Disc with software, drivers and user manual
3. Remote control with batteries and receiver cable
4. Quick Start Guide
* Note: Depending on the version of your product, package contents may vary.
I. Installing the hardware (see Figure I)
Store the card in the anti-static packaging until you actually install it.
•
Divert any possible electrostatic charge from your body by touching the casing of your PC.
•
Turn off your computer and any peripheral devices connected to it. Disconnect your computer from
the power supply as well as all necessary cables and components.
•
Loosen the computer cover screws, and remove the cover.
•
Select an available PCI slot. Loosen the slot cover on the back panel of the computer. Make sure to
keep the screws in a safe place.
•
Insert the card in the available PCI slot. Hold it firmly on the upper edge and ease it down into the
slot by applying even pressure on both ends. Press down on the upper edge until the card fits
securely in the expansion slot.
•
If you cannot easily insert the card, do not use force because this can bend and damage the contact
springs to the socket connector. Instead, remove the card and try to insert it again.
•
After you have inserted the hardware, tighten the card retaining bracket firmly onto the back of the
computer.
•
Now, put the cover back onto your computer and reconnect the peripherals and the power supply.
II. Connecting devices (see Figure II)
•
Connect your antenna to the antenna input socket on your hardware.
•
Connect the remote control receiver cable to the remote input terminal. (optional)
III. Setting up the remote control (see Figure III) (optional)
•
Secure the free end of the receiver cable to your monitor or computer casing with the tape strips
included in the package.
•
Make sure that the space between the remote control and receiver is unobstructed.
•
Insert the batteries in the remote control.
IV. Installing the software
You need to have Administrator rights to be able to install the program. If the "Add new hardware"
dialog window appears during installation, press cancel.
•
Insert the installation disc in the corresponding drive of your computer. The setup program now
either starts automatically or you can start the autorun in the setup directory on the installation disc.
•
Now follow the installation instructions displayed on the screen.
•
After installation, you will be prompted to restart your computer. This restart needs to be done in
order for the software to function properly.
Online Support: Interactive support per E-Mail, FAQs.
Visit us at http://www.pctvsystems.com
PCTV Systems S.A.R.L. hereby declares that this TV reception equipment complies with the
fundamental requirements and other relevant terms and conditions of EC directive number
2004/108/EC.
The EC and FCC declarations of conformity and identical construction can be downloaded from
http://www.pctvsystems.com/compliance.
Box Contents
Installation

Service and Support

and select your product.
CE/FCC Conformity
Specifications are subject to change without notice or obligation.