KitchenAid KSMSFTA Manual Del Usuario página 6

USING THE SIFTER+SCALE ATTACHMENT
3
4
ASSEMBLING THE SIFTER+SCALE ATTACHMENT
1
TIP: Aligning the handle tab on the chute with one of the notches as you lower the swivel
chute into the sifter housing will help you to line up the marks.
2
3
4
6 | USING THE SIFTER+SCALE ATTACHMENT
Insert the attachment shaft housing into the
attachment hub, making certain the power shaft fits
into the square hub socket. If necessary, rotate the
attachment back and forth. The pin on the attachment
housing will fit into the notch of the hub rim when in
the proper position.
Tighten the Stand Mixer attachment hub knob
clockwise until the attachment is completely
secured to the Stand Mixer.
To install the swivel chute: Lower the swivel chute
into the sifter housing at an angle, aligning the marks
on the swivel chute with the marks above the notches
on the inside of the sifter housing. Properly installed,
swivel chute will be seated securely in the sifter
housing and will rotate easily.
To install the sifter assembly: Lower the sifter into the
sifter housing at an angle so that the drive shaft can
be inserted into the sifter housing. Once the shaft is
inserted all the way, press down on the sifter, opposite
of the shaft, to click it into place.
To install the scale: Place the scale on top of the sifter
housing with the digital scale display facing away from
the Stand Mixer, and slightly left of center. Twist the
scale counterclockwise until it locks into place.
To install the ingredient hopper: Align the ingredient
valve with the corresponding notch on the scale, and
lower the hopper onto the scale until fully seated.