Installing The Interface - Axxess AFSI-02 Instrucciones De Instalación

Applications
FORD
Escape 2009-2012
F-150 2009-2012
F-150
(without 4.2" or 8" screen)
2013-up
Focus 208-2011
Fusion 2008-2012
Mustang 2009-up
Taurus 2010-2012
MERCURY
Mariner 2009-2011
AFSI-02

Installing the Interface

From the AXXESS 16-pin harness
• Connect the Red wires to the ignition/accessory wire of the aftermarket radio.
• Connect the Orange/White wire to the illumination wire of the aftermarket radio. If the
aftermarket radio does not have an illumination wire, tape off the Orange/White wire.
• Connect the Blue/White wire to the amp turn on wire of the aftermarket radio (note, wire
must be connected even if there isn't an amp in the vehicle).
• Connect the Brown wire to the mute wire of the aftermarket radio. If the aftermarket radio
does not have a Mute wire, tape up the Brown wire (note, if the mute wire is not connected
the radio will turn off when OnStar is active).
• Connect the White wire to the left front positive speaker output of the aftermarket radio
• Connect the White/Black wire to the left front negative speaker output of the aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the aftermarket radio.
Tape up the following wires as they will not be used in this application:
• Green wire
• Green/Black wire
2
• Purple wire
• Purple/Black wire