Installing The Frst-2; Programming Swc; Audio Level Adjustment - Axxess FRST-2 Instrucciones De Instalación

• With all the connections completed, plug the 22 and 16-pin harnesses into the FRST-2.
• Plug the 24 and 26-pin Ford harness into the vehicle side harness, and plug the
aftermarket radio harness into the aftermarket radio.
• Reconnect the negative battery terminal.
• Initialize the interface by cycling the key by (1) turning the ignition "on" for 30 seconds,
(2) then back off, and then (3) back on again to test the radio.
1.
Turn on the ignition.
2.
The LED will begin to blink rapidly.
3.
Turn on the aftermarket radio.
4.
Tap "Volume Up" until radio responses.

Audio Level Adjustment

• Start your vehicle and turn on the radio
having audio playing.
• Turn your aftermarket radio's volume up ¾
of the way.
• With a small screwdriver adjust the
potentiometer clockwise to raise the audio
level and counterclockwise to lower the
audio level.
• Once at desired level your audio
adjustment is complete.
Continued on next page
FRST-2

Installing the FRST-2

Programming SWC

6
POTENTIOMETER