Flex FT161 Manual Del Operador página 3

SAFETY RULES FOR COLLATED SCREW MAGAZINE
WARNING
result in electric shock, fire and/or serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
The collated screw magazine is designed to
only be used with the FLEX FX1611 drywall
screwdriver.
Observe all operating instructions and
safety regulations contained in the manual
for the FLEX FX1611 drywall screwdriver.
Before use, ensure that the magazine is
properly attached to the power tool.
Avoid body contact with grounded (or
earthed) surfaces such as pipes, radiators,
ranges and refrigerators. There is an
increased risk of electric shock if your body is
grounded.
Detach the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
When driving screws, never reach into
the magazine. Keep hands clear of the
advancing mechanism and the spot where
the screw is being driven.
Do not use the magazine as a gripping
surface.
Hold power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden
wiring. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock.
Use only screw strips with screw sizes #6,
#7 and #8 with this magazine. Only insert
screw strips when the screwdriver is turned
off and the trigger is locked.
Read all safety warnings, instructions, illustrations and specifications
provided with this power tool. Failure to follow all instructions listed below may
WARNING
Some dust created by power sanding, sawing,
•
grinding, drilling and other construction
activities contains chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints.
–
Crystalline silica from bricks, cement, and
–
other masonry products.
Arsenic and chromium from chemically-treated
–
lumber.
Your risk from these exposures varies,
•
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
–
Work with approved safety equipment, such
–
as dust masks that are specially designed to
filter out microscopic particles.
Avoid prolonged contact with dust from power
–
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing
and wash exposed areas with soap and water.
Allowing dust to get into your mouth or eyes or
to lie on the skin may promote absorption of
harmful chemicals.
-3-