Flex FT161 Manual Del Operador página 8

ROTATING THE MAGAZINE (FIG. 8)
This collated magazine has the ability to rotate
without being taken off the drywall screwdriver.
To rotate, grip the top portion of the magazine
with one hand, while holding the drywall
screwdriver with the other hand, then rotate the
magazine. An audible "click" indicates that the
magazine is positioned at one of 12 detents
spaced 30° apart.
DRIVING IN SCREWS (FIG. 9)
a. Insert the collated screw strip.
b. Set the screw-in depth.
c. Set the direction of rotation, on your drywall
screwdriver, to forward rotation.
d. Grip the drywall screwdriver with both hands
on the handle and assume working position.
e. Place the shoe against the workpiece to be
screwed into. Hold the drywall screwdriver at
right angle to the workpiece surface
f. On your drywall screwdriver: depress and
hold down the trigger switch, then press the
lock-on button to lock the trigger switch. The
screw will be driven into the workpiece until
the set screw-in depth is reached. Check the
screw-in depth and change if required.
NOTE: When the preset screw-in depth is
reached, the drive is disengaged and the bit will
stop spinning while the motor is still running.
g. Repeat the operation to drive more screws.
h. When you have finished driving screws, turn
off the drywall screwdriver.
At the end of work, move the direction-of-
rotation selector, on the drywall screwdriver, to
the middle position.
OPERATING INSTRUCTIONS
Fig. 8
Fig. 9
-8-