Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
STEP 1
SKYMAXX Model
00-97500i, 00-97510i
Refer to the above table for roof size opening. If you are
replacing another type already installed, remove the old existing
roof vent. Remove all old roof sealant for a minimum of 5 cm (2
inches) entirely around the roof opening.
STEP 2
Measure the thickness of the roof opening. NOTE: For curved
roofs, measure the thickest part of the roof.
VEHICLE ROOF
THICKNESS
23 – 40 mm
40 – 60 mm
STEP 3
Prior to installing the SKYMAXX ROOFLIGHT over the roof
opening, apply a continuous strip of a flexible non-hardening
sealing compound (e.g. SikaLastomer-710) to the underside of
the flange in the grooved space.
CAUTION!
When installing your SKYMAXX ROOFLIGHT,
only use a caulking/sealant compatible with the flange (plastic
product) and the roof surface. DO NOT use materials
containing solvents such as or similar to Xylene, Toluene,
Methyl Ethyl Ketone (MEK), Acetate or Acetone as they can
damage the flange. Also, Polysulfide (Thiokol) type sealants
must be avoided.
If in doubt, please contact the manufacturer of your caravan for
further information.
STEP 4
Insert the SKYMAXX ROOFLIGHT into the roof opening with the
hinged section facing the front of the vehicle with the ceiling
flange centered in the opening. Press down on the flange to
compress the sealant to seal to the roof.
STEP 5
After the SKYMAXX ROOFLIGHT has been installed, remove
the excess caulk that may have squeezed out. Using a sealer
such as Dicor self-leveling lap sealant or similar caulking, apply a
bead (approximately 5 mm dia.) along the outside edge of the
flange all the way around the Rooflight.
THIS COMPLETES THE ROOF TOP PORTION OF THE
INSTALLATION
Skip to page 4 for interior installation of SKYMAXX
Plus
Roof Opening
400 mm x 400 mm
LENGTH OF
SCREW
40 mm
60 mm
Publicidad
Tabla de contenido
