Wet Area LED Lights | Owner's Manual
Section 2.
Figure 1.
Fixture Assembly
3
1
Figure 2.
Attach Light to the Docking Ring
Installation Instructions
2
ENGLISH
1.
Assemble fixture as shown in
figure 1.
2.
Lay the fixture(s) out where
you want to install them.
3.
Install fixtures by inserting
the stake into the ground. Do
not use a hammer in direct
contact with the product. If it
is difficult to drive the stake,
remove the screw and lamp
holder, then place a pipe
arround the top of the stake
and use a mallet against the
pipe to drive it.
4.
Properly prepare the
end of the light cable to
securely connect it to the
12VAC output of a Class
2 transformer that is listed
or certified by a Nationally
Recognized Testing
Laboratory (NRTL) for the
intended use.
Page 3