lauson AFF111 Guia De Inicio Rapido página 4

LAUSON
ASSEMBLY INSTRUCTIONS
Please assemble correctly by the following orders when using:
1. ASSEMBLY THE STAND (picture 2)
•
Fix the bars (19).
•
Put the standing shaft (18) on the cross bars.
•
Screw the standing shaft on the base if it is necessary.
2. THE WHOLE ASSEMBLY (picture 3)
•
Link the fan mainbody and the standing shaft (18) together by the fixing screw
(15) and then fix them.
•
Loosen the fixing screw (17) and pull the electroplated pipe to the height needed and
them fix it firmly.
3. REAR NET ASSEMBLY (picture 4)
•
Screw the blade fastening screw out in clockwise direction and screw the net
fastening screw out in anti-clockwise direction.
•
Fix the rear guard onto the three pillars of the motor front shell.
•
Screw the net fastening screw (7) tightly in clockwise direction.
4. THE ASSEMBLY OF FAN BLADE (picture 5)
•
Put the fan blade onto the electrical axle centre and the axle centre bolt must be
pressed to the end of the concave notch at the back of the fan blade. They must be
tallied completely.
•
Screw the screw into the electrical axle centre in anti-clockwise direction and then fix
it.
5. FRONT NET ASSEMBLY (picture 6)
•
Put the hook of the front guard ring on the top of rear net.
•
Put the rear net into the front guard ring to make them tally completely.
•
Tighten the fastening screw of the lower of the front guard ring.
OPERATING INSTRUCTIONS

This fan has three types of speed control.
Weak
Middle
Strong

You can choose the up and down angle and control the wind direction freely.

Press the oscillate control knob, the fan begins to wave. Pull the button, the fan stops
waving.

Heigth regulation: Loosen the fastening screw (17), regulate the electroplated pipe to
the needed height.
0
1
2
3
AFF111
4
EN