Depth Adjustment; Water Line - Sub-Zero IC-18FI Guia De Instalacion

INSTALLATION
Alignment

DEPTH ADJUSTMENT

Adjust the depth of the unit to fit flush with surrounding
cabinetry. Follow these steps for a precision fit:
Place decorative panel on a protected work surface.
1
Place the panel thickness gauge next to the panel to
determine which notch corresponds with the panel thick-
ness. Refer to the illustration below. Once the proper
notch has been determined, mark that notch with a
marker.
With the door closed, position the top of the unit using
2
the panel thickness gauge. Refer to the illustration
below. Insert a #8 x 1 / " stainless steel screw above the
2
hinge, then insert a #8 x
handle side of the unit. For narrower units, the door may
need to be opened to access the handle side screw
location. Repeat the process to align the bottom.
ANCHORING
Once the top and bottom are aligned, verify doors and
drawers open properly, then install remaining screws in each
side trim.
PANEL THICKNESS
GAUGE
Panel thickness.
1 / " pan head screw on the
2
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
FRONT OF
UNIT
Unit depth.

Water Line

Purge the water line prior to final connection to the unit. This
will remove any debris that may be present in the tubing
from installing the new water line. Connect the plastic tubing
from the unit to the house water supply line with the fitting
connection kit provided. Check all water line fittings for
leaks.
Locate the water line in the notch as shown in the illustration
below.
IMPORTANT NOTE: If a reverse osmosis system used, it is
recommended that the water filtration system be bypassed
by removing the filter.
Water lines can not be exposed to
IMPORTANT NOTE:
freezing temperatures.
NOTCH
WATER LINE
CONNECTION
Water line.
|
subzero.com 9