Front Panel - Ampro Audiolab LIVE SNAKE 16.8 Manual Del Usuario

3. CONTROLS

Front panel

1. Power switch Push the top part of the switch
to turn on your unit. Push the bottom part of
the switch to turn it off.
2. USB upgrade port This port use to upgrade
firmware.
3. Power LED This LED indicates if the unit is
power on by lighting on.
4. Phantom power switch Turn the switch up to
supply the 48V phantom power to the corre-
sponding input channel.
5. Analog input channel XLR jack for inputting
analog signal. The PUSH table can be used to
release a connecting cable.
6. Input gain control Adjust the input gain from
0dB to +40dB.
7. Phantom power LED This LED indicates if the
48V phantom power is supplied to the relative
channel by lighting on.
8. Signal clip LED This LED will be lighted red af-
ter the signal is >+10dB to indicate the relative
channel is experiencing a signal overload.
9. Signal LED This LED indicates status of the
relative channel's input signal. It will be light
green slightly when the signal is >-10dB.
10. Analog output channel XLR jack for output-
ting analog signal.
English version
P. 5
- AUDIOLAB Live Snake 16.8