TruTalk TK14 Manual Del Usuario página 12

USING YOUR RADIO, Continued
Selecting a Channel, Continued
5 seconds, the unit will return to the last channel used
and return to operational mode
Selecting a PrivateTalk CTCSS Channel - Press
and release the MODE button until the small numbers
beside the main channel numbers begin to flash.
Select the desired sub-channel by using the UP (!)
or DOWN (") buttons. When the desired PrivateTalk
code is displayed, press and release the P-T-T to select
it. If no selection is made after 5 seconds, the radio will
save the last change and return to operational mode.
To exit without saving your last setting, press and
release the Call button.
Receiving a Call - The radio is continuously in
receiving (RX) mode when powered on. When you
receive a call on the current channel, the RX / TX
indicator icon (located on right side of LCD panel)
will flash.
Transmitting a Call - To reply to a received message,
or initiate a new message, press and hold the P-T-T
button on the side of the TK14. For the best results,
speak at a normal rate, in a normal tone - placing the
radio microphone approximately 2 inches from your
mouth. When you have finished your message, release
the P-T-T button. The radio's RX / TX indicator icon will
11