Installing the Heki 3 Plus
7
Installing the Heki 3 Plus
WARNING! Beware of injury
!
Disconnect the vehicle power supply before you begin and make
sure it cannot be restarted.
NOTICE!
A
Make sure that you do not damage any cables during installation.
See fig. 4
If you would like to connect the lighting:
➤ Lay the power supply line in the middle on the long side, where the crank
should go.
Supplementary to fig. 5
The scope of delivery includes a mounting frame, which is suitable for roof
thicknesses of 25 – 32 mm. For roof thicknesses of 33 – 60 mm, you need to
have a suitable mounting set (see table).
➤ Measure your roof thickness W.
➤ Choose a suitable mounting set:
Roof thickness
25 – 32 mm
33 – 39 mm
39 – 46 mm
46 – 53 mm
53 – 60 mm
See fig. 6
➤ Check that the roof light has sufficient space around it (approx. 1 to 2 mm)
in the roof opening.
See fig. 7
➤ Clean the roof opening in the mounting area.
18
Mounting
bracket colour
Grey
Black
Yellow
Blue
Red
Screws
∅ 4 x 25 mm
∅ 4 x 32 mm
∅ 4 x 40 mm
∅ 4 x 46 mm
∅ 4 x 52 mm
Heki 3 Plus
Item no.
Included in the
scope of delivery
9104100245
9104100246
9104100247
9104100248
EN