Dometic Heki 3 Plus Instrucciones De Montaje Y De Uso página 21

Heki 3 Plus
See fig. 8
NOTICE!
A
Observe the instructions of the sealant manufacturer.
➤ Seal the mounting frame with a flexible non-hardening sealing compound
(e.g. Sika Lastomer-710).
See fig. 9
➤ Check the direction of travel when installing.
You can fit the roof light sideways (hinge-side at front in direction of
travel) or lengthways (hinge-side on left or right in direction of travel).
➤ Place the outer frame in the middle of the roof opening.
NOTE
I
Pay attention to the power supply lines.
➤ Press the outer frame in the roof slightly so that the packing compound
spreads out.
See fig. 0
➤ Place the 16 mounting supports on the inside of the vehicle all the way
into the recess of the outer frame.
➤ Attach the 16 mounting supports using the fastening screws
To do this use the large holes in the mounting supports.
➤ Tighten the screws 10 minutes after installation.
See fig. a
You need to remove the lamps to be able to tighten the inner frame.
➤ Take the lamps out of the holders carefully and let them hang by the
cables (A).
See fig. b
The lamps are fitted at the factory and installed on the short side of the inner
frame. If you do not want to connect the lamps, dismantle them. If you want
to install the lamps on the long side, you need to dismantle them and replace
them on the long side.
EN
Installing the Heki 3 Plus
.
∅ 4
19