Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING THE BLADE

See Figures 7 - 9.
Replace blades when worn down to indicator hole on blade.
 Stop the engine and remove the spark plug wire.
 Align the slot in the flange washer and gear case with the
slot in the flange; place the holding pin through all three
slots to secure in place.
 Using a 1/2 in. socket wrench, turn the blade nut clock-
wise to loosen.
 Remove the old blade from the edger shaft.
 Clean debris from the edger shaft and flange washers.
 Center the new blade on the flange washer, making sure
the blade sits flat.
 Install the cupped washer with the hole off of the blade
surface.
 Install the blade nut onto the edger shaft.
 Using a 1/2 inch socket wrench, turn the blade nut coun-
terclockwise onto the edger shaft and tighten securely.
MAINTENANCE
 This replacement part is available from the place of pur-
chase, or by calling 1-800-332-1631.
NOTE: Always make sure the blade is correctly installed
and securely fastened before each use.
ATTACHING THE STORAGE HANGER
See Figure 10.
There are two ways to hang the attachment for storage.
 To use the hanger cap, push in the button and place the
hanger cap over the end of the attachment shaft. Slightly
rotate the cap from side to side until the button locks into
place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.
STORING THE ATTACHMENT
 Store the attachment in a dry, well-ventilated place that
is inaccessible to children.
 Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
9 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido