Adjustments; Selection Of Stapling Positions; Setting And Storing The Stapling Positions - Cassese CS 59 Livro Técnico De Instrucciones

13
19 mm Wrench
4 mm
x 4
x 4
4 mm
50 MM BETWEEN
THE SUPPORT OF
!
FOOT AND THE
GROUND.
-S/E TABLE
1
CS 59/79
-S/A TABLE EXTENSION
Z 3585 -MESA DE EXTENSION
-U-GR. TISCHVERLANGERUNG
2
3
!
5
The CS 59 is designed to join mouldings in one or two places (positions) without limitation of the
number of wedges in any of those places. The selection depends on the width and thickness of the
moulding to join.
50 MM
MINIMUM
2 mm MINIMUM
As a general rule a MINIMUM 2 mm clearance (less than 1/8") above the wedges shall
be respected.
Same sized wedges can be stacked in order to avoid to have to change the cartridge size
when joining frames with different thickness.
AS A GENERAL RULE, THE JOINING MUST BE CARRIED OUT AS
CLOSE TO THE THICKEST MOULDING PART(S) AS POSSIBLE .

SETTING AND STORING THE STAPLING POSITIONS

Unlock the stapling position lock handles P1, P2 and P3.
B1

ADJUSTMENTS

SELECTION OF STAPLING POSITIONS

(Approx.1/8'')
2 mm MINIMUM
90° JOINING ANGLE ASSEMBLY
P 1
P3
B
P2
6
(Approx.1/8'')