Selection Of Top Presser; Adjustment Of The Assembly Angle - Cassese CS 59 Livro Técnico De Instrucciones

Standing in the work position used of reference for explanations (behind the machine; see
Fig 2, page 1), with your left hand, put the first moulding chop in front of the left (1
P2
B
E
WEDGE
EXIT
B2
FRONT OF MACHINE
P1
E
WEDGE
EXIT
In case you would like to insert wedges in between these two positions, or if you are
working with a very small moulding and would like to insert wedges only in one place, you
can use the lever P3 located on the limit stop B.
This intermediate lever P3 also enables you to stack wedges (on top of each other in the
same position) without risk of missing the stacking operation (not pushing the first wedge
deeper inside).
B
backfence B1 and bring the chop in contact
with the right (2 nd ) backfence B2.
For the stapling position close
to the outside of the frame :
Move forward the 90° joining angle assembly
B1
E until the place where you want to insert the
wedge(s) has been reached by the WEDGE
EXIT (see picture). Then bring the lever P2
against the limit stop B and tighten it.
For the stapling position close to the inside
of the frame :
Move the 90° joining angle backwards, until
you have reached the furthest
position to the inside of the frame where you
want to insert wedge(s).
Then bring the lever P1 against the limit stop
B and tighten the lever.
Now the two positions of joining are set and
the machine's 90° angle can move only
within the limits of these two positions.
P3
E
7
st )
Make sure that the distance between the moulding's top
and the presser's bottom is not more than 30 mm (1 ¼").
If the distance is bigger than this, use another (longer)
top presser to reduce the distance.
Triangle top pressers are good for flat mouldings
or for mouldings presenting a flat or horizontal
area to come down on. The green or orange rubber
ends are good for complicated forms (uphill,
downhill or reverse mouldings).
BLACK TRIANGLE PRESSER
WHITE TRIANGLE PRESSER
GREEN ROUND RUBBER ENDS
YELLOW ROUND RUBBER ENDS
If several cutting machines are being used in your production or if you receive your
mouldings already cut by your suppliers (chop service), the angles of the mouldings will
be slightly different from one cutting machine to the other. The joining angle of your CS
59 can be adapted to find precisely the cutting angle of your cutting machine.
If the corner is open towards outside, unscrew (turn anti-clockwise) the angle adjustment
screw AS (see Fig 1 page 1) a little to correct the fault and check again.
Outside
If the corner is open towards inside, screw in (turn clock-wise) the angle adjustment screw
AS (Fig 1 page 1) to correct the fault.
SELECTION OF A TOP PRESSER END
PRESSER
30 mm (1
MAXIMUM
MOULDING
FOR HARDWOODS Fixing in support with
FOR SOFT WOODS 2.5 mm Allen key.
FOR HARDWOODS 1 long and 1 short
FOR SOFT WOODS 1 long and 1 short

ADJUSTMENT OF THE ASSEMBLY ANGLE

If you get this result, check your cutting angle, which is wrong
in this case because it is less than 45° .
Carry out the adjustment of the angle of your cutting
machine.
IT IS IMPOSSIBLE TO MAKE A RECTANGLE
FRAME WITH ANGLES SMALLER THAN 90°.
8
')
1/4'
Inside