Atlantic SOLCCSL2 Manual De Operación página 3

Iluminación con colores cambiantes para elementos sólidos del paisaje
Ocultar thumbs Ver también para SOLCCSL2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(see Figure 1) or under a core-drilled stone or pot
(see Figure 2). The light is designed to be installed
in any tee that has 1" female threads. If the tee is
larger than 1", a reducing bushing with 1" female
threads will be needed. Install the light in the back
of the tee, with the light facing the water outlet.
Apply a small amount teflon tape or paste to the
threads of the light and thread the light into the
fitting. Do not use the cord to twist in the light or
allow it to become twisted when tightening. You
can remove the driver from the cord when pulling
it through conduit. Once the cord is through the
conduit, reattach the driver before connecting the
light to a power source. Failure to reattach the
driver will damage the light and void warranty.
Hardscape Wall Light Installation
Hardscape Wall Lights are designed to be installed into walls and columns, just
under the capstone. The LED light strip and driver can be replaced without
removing the capstone. The cord between the driver connection and the light
is approximately 19', enabling the driver to be left outside of the column or wall
for future access (see Figure 3). When laying the base course of stone, either
notch the cord into the wall or leave a notch slightly larger than ¾" to pass the
cord through. If multiple lights are going to be installed, the notch will need to be
slightly larger to accommodate multiple cords. Removing the driver will allow the
cord to be pulled through the notch; reattach the driver before connecting the
light to a power source. Failure to reattach the driver will damage the light
and void warranty.
Figure 3.
Driver
Figure 2.
¾" KF tubing
Figure 4.
1" Female
threaded T
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Solcch06Solcch12

Tabla de contenido