HoMedics THERA-P MCS-125H-THP Guia De Inicio Rapido página 4

Kneading Shiatsu
Massage Cushion
with Heat
NOTE: When
"POWER" button
is pressed for first-
time use, the moving
shiatsu mechanism
will automatically
move to the lowest
position before
starting a massage
program. After initial
use, mechanism
will always park at
lowest position. See
note below regarding
parking.
NOTE: The moving
massage mechanism
always "parks"
or finishes in its
lowest position. It
will continue to this
position after the
power has been
turned off. If the
electrical supply is
interrupted, when
power is restored,
the mechanism will
"park" or move to its
lowest position.
6
Power Button
To turn on the massage functions, first press the POWER button.
The L.E.D. indicator will illuminate and confirm your selection.
To turn off the massage functions, simply press the button
again. The L.E.D. indicator will blink while the Shiatsu massage
mechanism returns to its lowest point and then it will turn off.
Kneading Massage
Shiatsu is a deep kneading circular massage. This unit features
a massage mechanism that travels up and down the back of the
cushion.
Mode Button
Choose from 3 preset programs where the massage travels up
and down in a specific area of the back, either Full Back, Upper
Back or Lower Back. To select a program, simply press the Mode
button and the L.E.D. will illuminate the active program. Continue
to press the Mode button until the desired program is selected.
Heat Button
For soothing heat when massage is on, simply press the heat
button and the corresponding red L.E.D. light will illuminate. To
deselect, press the button again and the corresponding L.E.D.
light will turn off. For your safety, heat cannot be turned on if
massage is not selected.
NOTE: There is a 15-minute auto shut off on the unit
for your safety.
7