Mowing; Technical Data - Fieldmann FZV 4001-E Manual De Uso

EN 18 Mowing | Technical data
Push the aeration cylinder of the verticutter 18 onto the drive wheel shaft so as the pin 19
snaps into the slot in the drive wheel shaft 20.
Screw the bearing bush 17 to the bottom of the cover but do not tighten it too much.
If the cylinder of the verticutter is in the wear adjustment position 3 and if it is worn out, the
cylinder must be replaced by a new one.

10. MOWING

For verticutting convenience, it may be best to start working at a point closest to the power supply
and to work your way away from the power supply. Verticut / aerate the lawn at a right angle
from the power supply and place the power cable to the side which has already been treated (E).
Attention! When verticutting, do not allow the motor to labour, in particularly heavy
conditions. When the motor labours the speed of the motor drops and you will hear a change
in the engine sound. When this occurs, stop mowing, release the switch lever and reduce the
verticutting / aeration height. Failure to do so could damage the machine.
Note: The engine is protected by a safety cut out which is activated when the blade
becomes jammed or if the engine is overloaded. When this occurs, stop the
machine and remove the plug from the power supply. The safety cut out
will only reset when the switch lever 10 is released. Before continuing to
mow, clear any obstructions and wait for a few minutes for the safety cut
out to reset. During this time do not operate the switch lever 10 as this
will prolong the time to reset the safety cut out. If the machine cuts out
again, increase the verticutting / aeration height to reduce the load of
the engine.

11. TECHNICAL DATA

Electric verticutter .................................................................................................................................. FZV 4001-E
Rated power .................................................................................................................................................. 1300 W
Blade length ...................................................................................................................................................... 32 cm
Cutting height ............................................................................................................................... +3/-3/-6/-9 mm
Grassbox capacity ............................................................................................................................................. 40 L
Weight ................................................................................................................................................................... 10 kg
Protection rating .................................................................................................................................................. IPX4
Aerator cylinder working speed ................................................................................................. 3900±5% rpm
Sound power level ..................................................................................................................................... 96 dB(A)
Vibrations ...................................................................................................................................................... 40 m/s2
The User's Manual is in a specific language version.
(Fig. 6)
FZV 4001 E