General Information - Southwire 41171N Instrucciones De Operación

CONTINUITY TEST MODE
5. Touch the test lead probes to the component or wire you wish to check.
6. If the resistance is approximately 30 or less, a steady audible tone will
sound and a continuity connection symbol
on the LCD screen. If the resistance is greater than 30 , the buzzer
will not sound and the continuity connection symbol will not appear
on the LCD screen.

GENERAL INFORMATION

Low Battery Indicator
When the battery voltage drops below approximately 2.7V, When the battery voltage drops below approximately 2.7V,
the Low Battery Symbol the Low Battery Symbol will be displayed on the LCD screen will be displayed on the LCD screen
indicating that the batteries need to be replaced.
When this occurs, you should replace the batteries immediately. When this occurs, you should replace the batteries immediately.
If the battery voltage falls below 2.4V, the voltage tester will beep 5 times If the battery voltage falls below 2.4V, the voltage tester will beep 5 times
and then immediately turn off.
will appear
17
GENERAL INFORMATION
Replacing the Battery
WARNING:
To avoid electric shock, remove test leads from the voltage tester before removing
the battery cover.
1. Remove the one Phillips
screw from the battery cover
located on the back of the
41171N voltage tester.
2. Remove the battery cover.
3. Install two (2) new AAA
batteries.
4. Re-install the battery cover
and tighten the screw. Be
careful not to over tighten the
screw.
Specifications
6-600V AC/DC
CAT IV 600 V, class 2, Double Insulation
50 Hz/60 Hz
32 °F to 104 °F(0 °C to 40 °C )
14 °F to 122 °F(-10 °C to 50 °C )
Max 85 % RH (NC)
≤6560 feet(2000 m )
6.5 feet (2 mètres )
CAT IV 600 V
100 V AC to 1000 V AC
2 - AAA, 1,5 V each
18