BOHELL SC400 Manual Del Usuario página 16

and remove any obstructions such as nails,
staples, screws, string, rags, cloths and other
debris.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
DESCRIPTION
A Start-up Switch
B Lock Button
C Jig Saw Blade
D Shoe
E Dust extraction
F Set of screws
G Guide Roller
H Allen wrench
I Saw blade holder
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Ensure that the voltage indicated on the rating
label matches the mains voltage before plug-
ging in the appliance.
- Ensure that the selected tension on the voltage
selector coincides with the tension of the mains.
FITTING THE ACCESSORIES
- Unplug the appliance from the mains.
- Loosen the set of screws (F) using the allen
wrench.
- Slide the saw blade up to the stop in the saw
blade holder (I). If the saw blade doesn't reach
the stop, enter it until the saw blade reaches de
saw to the saw blade holder.
- Make sure that the back of the saw blade en-
gages in the slot of the guide roller (G).
- Tighten the set of screws (F) firmly.
- Regularly check if the saw blade is firmly
attached. If necessary fasten the set of screws
while the appliance is unplugged.
-
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
switch.
- Place the appliance against the surface you
want to work.
- Allow the jig saw reach its maximum speed
before commencing to cut.
LOCKING BUTTON:
- Activating the locking button allows you to
operate the appliance without having to depress
the run button.
- To activate this function press button (B) while
holding down the on/off switch.
- To deactivate this function press the on/off
switch right down.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by releasing the on/off switch.
- Unplug the appliance from the mains.
MAINTENANCE AND CARE
- WARNING! Always unplug the machine before
carrying out work on it.
- Inspect the mounting screws: regularly inspect
all the mounting screws and ensure they are
firmly tightened. Should any screw be loose,
tighten it immediately. Failure to do so could put
you at serious risk.
- The vents should always be kept clean and free
of obstacles.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
- Always use original supplies, designed specifi-