Installation And Connection - Oase biOrb Heater Set Instrucciones De Uso

- EN -
W A R N I N G
Danger of suffocation.
Keep plastic bags and small parts out of reach of ba-
bies and young children.
Intended use
biOrb Heater Set, referred to as "unit", may only be
used as specified in the following:
· As a thermostat controlled aquarium heater.
· Operate in accordance with instructions.
The following restrictions apply to the unit:
· Only use indoors and for aquaristic purposes in the
home (not for commercial use).
· Only operate with water at a water temperature of
+4 °C to +35 °C.

INSTALLATION AND CONNECTION

N O T E
· Ensure that the heater is immersed in water at
least up to the minimum immersion depth mark-
ing.
· The heater can be completely immersed in water.
· It is important to use the supplied holder for fitting
the heater. Ensure that the heater does not make
contact with the acrylic wall of the aquarium.
18
N O T E
The desired water temperature can only be achieved
if the heating capacity of the heater is suitable for the
volume of water in the aquarium (® Technical data)
and is positioned in an area with good water circula-
tion.
How to proceed:
5 B, C, D, E
· Turn the temperature controller to the desired
temperature value.
· Select one of the options for fastening the holder
in the aquarium.
· Insert the supplied suction cups into the holder by
twisting.
– Pay attention to the alignment of the tabs (they
should point upwards or to the side).
· Clamp the holder to the unit.
· Position the unit with the heating element pointing
towards the floor of the filled aquarium on a clean,
smooth surface in an area with good water circula-
tion.
· Fit the thermometer opposite the heater at ap-
proximately the same height.
biOrb Heater Set