Intended Use; Electrical Installation - Oase InScenio FM-Master 1 Instrucciones De Uso

- EN -

Intended use

InScenio FM-Master 1-3, in the following termed "unit", may only be used as a power supply distributor for correspond-
ingly suitable Oase products. The unit can be used at ambient temperatures of -20 °C to +45 °C.
Only connect such other devices and systems to the unit, which will not pose any danger to persons or assets in the
event of a malfunction of the transmitter or receiver or where such risk is eliminated by other safety measures.
Devices and systems bearing an increased risk of accident must not be activated or deactivated by means of the man-
ual transmitter.
Installation
So
How to install the unit:
• Remove the protection hood from the unit.
• Set-up the unit horizontally and water-protected, at a dry location, at least 2 m from the edge of the pond (B, C).
• Fully insert the ground stake (3) into the soil.
• Place the unit onto the ground stake (insert the ground stake in a corresponding mounting).
• Check its stability.

Electrical installation

This is how to connect the power supply:
• Push the female connector of the power supply (6) onto the unit plug (7).
The connection is made on the unit rear (D).
Commissioning/start-up
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Teach-in manual transmitter
Check the function of the manual transmitter by actuating one of its buttons. The LED of the manual transmitter must
light up. A maximum of 10 transmitters can be taught in. Depending on the terrain, the range is up to 80 m. When the
transmission power fades, replace the battery of the manual transmitter.
Prior to being able to start up the unit, harmonise the manual transmitter transmit signal with the receiver in the unit.
For this purpose, the receiver is equipped with a teach-in key.
How to teach-in the manual transmitter (D):
• Insert the teach-in pin (5) into the opening (8) until you feel a resistance. At this point you have reached the teach-in
key.
• Briefly press the teach-in key using the teach-in pin.
• Keep any button of the manual transmitter pressed for at least 3 sec.
This completes the teaching in of the receiver to the manual transmitter.
Deleting saved manual transmitters
How to delete the manual transmitters from the unit:
• Keep the teach-in key of the unit pressed for at least 5 sec. using the teach-in pin (5).
All saved manual transmitters are deleted.
12