Know Your Bench Grinder - KNOVA KN 7053 Manual Del Usuario

ELECTRICAL
ELECTRICAL CONNECTION
This tool is powered by a precision-built electric motor. It
should be connected to a power supply that is 120 volts,
60 Hz, AC only (normal household current). Do not operate
this tool on direct current (DC). A substantial voltage drop
will cause a loss of power and the motor will overheat. If the
tool does not operate when plugged into an outlet, double
check the power supply.
SPEED AND WIRING
The no-load speed of this product is approximately 3,600 rpm.
This speed is not constant and decreases under a load or with
lower voltage. For voltage, the wiring in a shop is as impor-
tant as the motor's horsepower rating. A line intended only
for lights cannot properly carry a power tool motor. Wire that
is heavy enough for a short distance will be too light for a
greater distance. A line that can support one power tool may
not be able to support two or three products.
GROUNDING INSTRUCTIONS
In the This product must be grounded. In the event of a mal-
function or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric
shock. This product is equipped with an electric cord having
an equipment-grounding conductor and a grounding plug. The
plug must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.

KNOW YOUR BENCH GRINDER

KNOW YOUR BENCH GRINDER
See Figure 2.
The safe use of this product requires an
understanding of the information on the
tool and in this operator's manual as
well as a knowledge of the project you
are attempting. Before use of this product,
familiarize yourself with all operating
features and safety rules.
Spark
shield
Fig. 2
WARNING
plug can result in a risk of electric shock. When
repair or replacement of the cord is required, do not
connect the grounding wire to either flat blade
terminal. The wire with insulation having an outer
surface that is green with or without yellow stripes
is the grounding wire.
Check with a qualified electrician or service personnel if
the grounding instructions are not completely understood,
or if in doubt as to whether the product is properly grounded.
Repair or replace a damaged or worn cord immediately.
This product is for use on a nominal 120 V circuit and
has a grounding
plug similar to
the plug
illustrated
in figure 1.
Only connect
the product to
an outlet having
the same
configuration as
the plug. Do not
use an adapter
with this product.
Spark
deflector
On/Off
4
switch
Improper connection of the grounding
Fig. 1
Grounding
pin
GRINDING WHEELS
Equipped with coarse and fine grinding
wheels to suit most applications.
ON/OFF SWITCH
The bench grinder features a front
access On/Off switch for
convenience and safety
Spark
shield
Work
rest
SPARK SHIELDS AND SPARK
DEFLECTOR
The spark shields and spark deflector
are provided to ensure your safety.
WORK REST
Provides a stable work surface when
performing most grinding tasks.
120 V
grounded
outlet