Operation - KNOVA KN 7053 Manual Del Usuario

ASSEMBLY
MOUNTING SPARK SHIELD ASSEMBLY
See Figure 6.
• Attach the spark shield assembly and bracket to the wheel
guard using a clamp
bracket, washer,
and hex head bolt.
• Tighten bolt
securely.
• Repeat above
steps for
the other side.
Clamp
bracket
Washer
Hex head
bolt
MOUNTING SPARK DEFLECTOR
See Figure 6.
• Using the two phillips head screws, washers, and lock
washers, attach the spark deflector to the top of
the wheel guard.
• Adjust the spark deflectors to within 1/16 in. (1.6 mm)
of the grinding wheel. Tighten screws securely.

OPERATION

WARNING Do not allow familiarity with tools to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure
to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
WARNING Do not use any attachments or accessories
not recommended by the manufacturer of this tool.
The use of attachments or accessories not
recommended can result in serious personal injury.
NOTICE:
Excessive pressure on a cold wheel may cause the wheel
to crack.
NOTICE:
Never sharpen or grind anything made of aluminum, brass,
or copper.
WARNING
Do not use wheels rated less than the
speed of this tool. Failure to heed this warning could
result in personal injury.
MOUNTING WORK REST
See Figure 7.
• Unscrew and remove the carriage bolt from
the work rest knob.
• Attach the work rest to the inside of the wheel
guard as shown.
Spark
NOTE: As the diameter of the wheel decreases with use,
deflector
adjust the distance between the wheel and the work
rest to maintain 1/16 in. or less separation.
Washer
• Tighten knob securely.
Lock washer
Phillips
head
screw
Spark shield
assembly
Fig. 6
APPLICATIONS
This product has been designed only for the purposes
listed below:
• Sharpening drill bits
• Sharpening lawn mower blades
• Sharpening chisels and flat screwdrivers
BASIC OPERATION
To be efficient and work as designed, your tools should
be kept sharp. Dull tools can and will cause accidents.
Bench grinders are ideal for sharpening tools such as chisels,
planer blades, scissors, etc., and for removing rust or corro-
sion. Grinders remove material rapidly so pressure is the key
to efficient grinding.
The proper way to sharpen a tool and avoid overheating is:
• Keep the object in constant motion, moving
it at an even pace.
• Never force a tool against the grinding wheel.
• Keep the tool cool by using a pan of water.
• The grinding wheel should rotate "into"
the object being sharpened.
6
Fig. 7
Work
rest
knob
Carriage
bolt
Work
rest