LEGRAND 430 604 Manual Del Usuario página 6

This product is designed for installing 10" to 24" led displays weighing up to 30kg (661lbs).
Note: You need to insert the bubble level system when you install the wall plate
Step 1 - Mount the wall Plate
1. Place the wall plate against the wall with the cable-routing hook
towards the bottom.
2. Secure the wall plate using one screw (A).
3. Using the bubble level system (E), carefully adjust the wall plate
until it is vertical.
4. Attach the remaining 4" screw into the wall plate and tighten.
Step 2 - Remove the monitor stand
To prepare the monitor (430 570 or 430 571) for wall mounting purposes:
- Disconnect all cables monitor face down on a non-abrasive surface.
While using your thumbs, press the bottom plastic cover to remove it:
Remove the 6 screws fixing the monitor to the stand and remove the stand:
The monitor is now ready for mounting with the wall bracket.
Step 3 - Attach the Arm to the LCD
1. If your LCD has a flat back, use the M4x12mm Philips Head Screw (C).
(Ex : 430 570 , 430 571)
Note: If your LCD has a recessed back, use the longer M4 x 30 mm
Philips Head Screw (D) and 3//1" spacers (F).
2. After you have determined the appropriate screws, use them to attach
the mounting plate to the back of your LCD displays.
.
87 mm