Blackstar Amplification CORE STEREO 10 V2 Manual Del Usuario página 11

11. Tap
The Tap switch is used to set the rate/time of the current 'focused' effect. The time
between each press of the tap button defines the rate set.
Once set, the Tap LED will flash in time with the set rate of the currently 'focused'
effect.
The Effects Table below shows the modifiable parameters:
Effects Table
Effect Segment Parameter
MODULATION
Phaser Mix
Chorus / Flanger Morph
Envelope Sensitivity
Tremolo Frequency modulation depth
DELAY
Linear Feedback
Analogue Feedback
Tape Feedback
Multi Feedback
REVERB
Room Size
Hall Size
Spring Size
Plate Size
This setting is saved when you store a patch.
12. Power Switch
This switch is used to turn the amplifier on and off; the white dot marks the ON
position.
13. USB
Plug a USB cable in here to connect the amplifier to a Windows PC or Mac.
Blackstar's INSIDER software offers a host of features and can be downloaded
from: www.blackstarinsider.co.uk
See the USB Audio section on page 15 for more information.
NOTE: The amplifier will appear on a personal computer as an audio capture device
within recording software.
Level Parameter
Depth
Mix
Depth
Amplitude modulation depth
Delay level
Delay level
Delay level
Delay level
Reverb level
Reverb level
Reverb level
Reverb level
Tap Parameter
Speed
Speed
-
Speed
Time
Time
Time
Time
-
-
-
-
11