Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSFER BETWEEN PARALLEL PHONES
10.
Setting paging number
1. In on-hook state, press and hold SET key, LCD displaysEL--
2. Key in "*" and the paging number (example "*1"and "*2" ), using DELkey to edit
3. Press SET key to confirm and exit.
Transferring the line from paralleled phones:
When a call comes, use one of paralleled phones to answer. Press"*" and the paging number that was set in
another telephone unit, the unit rings, pick up its handset or press
Notes:
1.
Please use same series phones to transfer as above operation. Any special services starting with "*"
offered by your Telephone company may not function properly.
2.
To get the best effect of this function, you should load the batteries before using.
ANTI-DIALING FROM PARALLEL PHONES FUNCTION
1. In on-hook state, press and hold #/= key for 3 seconds, LCD displays SPION
2. Press
key twice and then
3. Press and hold #/= key for 3 seconds again, LCD displays SPI OFF
When the anti-steal dialing is set to ON, users who want to dial using an extension via the same line will hear a
"DI-DI, DI-DI" beep continuously and will not be allowed to make a call.
SETTING RINGING TONE AND ADJUST RINGING VOLUME
There are 16 kinds of ringing tone and ringing OFF for selection:
1.
In on-hook state, press RING key, LCD displays ring 02 db8
2.
Press RING to select the desired ringing or set ring OFF.
3.
Press UP/+ or DOWN/- key to set ringing volume.
4.
Press SET to confirm and exit.
Note: The volume ranges from 1db-8db, with 8db being the loudest. Ring OFF is "Do Not Disturb" mode. If
the phone is set to this mode, the telephone will not ring when there is an incoming call.
ADJUST HANDS-FREE VOLUME
In hands free mode, press UP/+ or DOWN/- to adjust the hands-free volume, LCD displays the volume level
and there are a total of 4 levels.
SETTING PABX CODE
1.
In on-hook state, press and hold DELkey 3 seconds to set PABX code, LCD displays SET PCODE - and
the "-" flashes.
2.
Press UP/+ or DOWN/- key to set PABX code from 0 to 9 or -.
3.
If choose "-", it means no PABX code has been set.
4.
Press SET key to confirm and quit.
key to answer the incoming call.
21
Publicidad
Tabla de contenido
