Battery; Changing The Battery - Grillbot GBU101 Manual De Instrucciones

Battery

Grillbot Battery Li-Po 1400 mAh, with recharge
Use only the charger supplied by the manufacturer to recharge.
Use only the batter supplied by the manufacturer.

Changing the battery

To replace the battery, contact an authorized service center.
You can replace the battery yourself, as described below, you must be very careful to
correctly place the battery and store the cables when closing the cover Grillbot to avoid
damage.
1. The plastic cover is removed using an Allen key.
2. Click off the old battery and insert the new one. Here is a danger of explosion if battery
is incorrectly replaced. Replace only with the same or equivalent type recommended by
the manufacture.
3. Attach the plastic cover to the robot.
Warning! The batteries can explode in a fire.
Do not use or leave batteries near a heat source. Heat can melt the insulation
and damage other safety feature, possibly leading it to leak acid, overheat,
emit smoke, burst and/or ignite.
Charging the battery
Before first use, your Grillbot will need to be charged. The initial charge will take about
4 hours. Grillbot's built in sensor will prevent over charging.
Meaning the battery indicator on the LCD display
Battery 4-cell
Battery no cells
Battery cells are flashing
When the battery is low the LCD display will flicker, motors will stop working and will
beep for 15 seconds. The Grillbot will go into "sleep" mode after 60 seconds.
Note: When plugging in for charging, the LCD light will turn on and the
"START/STOP " button will be locked preventing the Grillbot from turning
on. The LCD light will turn off after 3 seconds when fully charged or
disconnected. When battery is fully charged, the battery level indicator will
be full. Alarm will beep for 15 seconds and LCD light will turn off.
The battery is fully charged
The battery is discharged
The battery is charging
29