Technical Data - JENCONS Powerpette Pro 266-185 Manual Del Operador

Introduction
The Jencons Powerpette ® Pro has been carefully designed and manufactured as a lightweight, cordless
pipetting aid for use with all plastic or glass pipettes from 1–100ml.
This new Powerpette is constructed in recyclable materials and operates on two rechargeable, long life,
environmentally friendly, 1.2V nickel metal hydride batteries. Powerpettes have uniquely formed finger
triggers to minimize any high pressure points. These triggers also control intake and dispense speeds.
A battery warning light (4) is triggered whenever the charge in the batteries is low and they should then
be recharged. Pipetting with Powerpettes can also take place while the units are connected to their
chargers (5).
Powerpettes have a conveniently located slide switch (3) which allows the user to select between three
modes of operation:
Slide switch position 'High' (top)
Slide switch position 'Low' (middle)
Slide switch position 'G' (bottom)

Technical Data

Batteries 2 x 1.2V nickel metal hydride
Battery service Life 500–1000 cycles from empty
Charger 75mA/h for 16 hours plug-in; UK, European, USA, Indian,
Japanese or Australian versions
Installation (over voltage) category II
Double insulation indicated on charger by symbol
Overall weight 180g without stand
Filter (8) Hydrophobic 25mm dia 0.45µm (fitted) plus two
additional spare filters
1x 0.45µm
1x 0.20µm
Case material ASA
Nosecone material (10) ASA
Pipette holder Silicone (9)
Pipette types Plastic or glass 1–100ml
2
Pro Operator Instructions
Suction and dispense at full speed (Blow-out)
Suction and dispense at reduced speed (Blow-out)
Suction at reduced speed, dispense by gravity (To Deliver)
7. Filter adaptor
8. Filter
9. Silicone
pipette holder
10. Nosecone
6. Charging jack
Pro Operator Instructions
1. Aspirate trigger
4. Low battery indicator
2. Dispense trigger
3. Mode selection slide switch
5. Charger
3