Publicidad
Idiomas disponibles
Idiomas disponibles
• Keep sharp objects away from lens — it is glass and can break.
• Do not immerse spotlight in water.
• Do not expose this unit to extremely high temperatures.
• Do not drop or throw spotlight. It contains glass and a nickel metal hydride rechargeable battery pack.
• Use only with AC or DC charging adapters that are provided with unit. Plug in the charging adapter at the spotlight first, then plug into the
charging source.
• Do not overcharge: Recharge up to 2 hours maximum.
• After charging/recharging, disconnect charging adapter or extension cord and wait 5 minutes before use.
• Do not crush, cut, pull or expose charging adapter cords to extreme heat.
• Position charging adapter cords so they do not become entangled or become a safety hazard. Keep charging adapter cords away from sharp edges.
• Use in a dry location only.
• Do not open body casing. There are no user-serviceable parts inside.
• Do not operate the spotlight without the lens in place.
• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting.
• Do not attempt to charge the unit if the charger is damaged – return the charger to manufacturer for repair or replacement.
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new spotlight. Read this Instruction Manual and follow the instructions carefully before using your
new spotlight.
CHARGING/RECHARGING THE SPOTLIGHT
This unit is shipped in a partially charged state. Charge unit BEFORE first use using the 120 volt AC charger for 2 hours or until the battery status
LED lights green. Charge after each use until the battery status LED lights green.
The battery status LED lights red when the unit needs recharging.
Charging/recharging using the 120 volt AC charger
• Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
• Insert the barrel connector of the AC charger into the 12 volt DC charging port on the back of the unit. Insert the plug end into a (powered)
standard North American 120 volt 60Hz outlet.
• Charge until the battery status LED lights green (approximately 1-1/2 to 2 hours).
Charging/recharging using the 12 volt DC charger (optional accessory)
• Make sure the spotlight is off (the trigger lock is in the off position and the trigger is not depressed).
• Plug the barrel tip of the supplied 12 volt DC charger into the 12 volt DC charging port.
• Insert the 12 volt DC plug end into the accessory outlet of your vehicle or other 12 volt DC power source.
• Charge until the green battery status LED lights (approximately 1-1/2 to 2 hours). DO NOT CHARGE FOR LONGER THAN 2 HOURS USING THIS
METHOD.
Note:
When using a vehicle's 12 volt DC accessory outlet as a charging source, be aware that some vehicles require you to turn on the ignition to power the
accessory outlet.
OPERATING INSTRUCTIONS
Important note: When either charger is plugged into the 12 volt DC port, the unit is in charging mode. The spotlight will not run with either of
the chargers plugged in.
Operating the spotlight
1. Disconnect from charger.
2. The On/Off trigger is located in the front of the handle of the spotlight.
3. To turn the spotlight on, squeeze the trigger.
4. To turn off the spotlight, release the trigger.
Note:
The On/Off trigger can be locked in the on position using the trigger lock bar on the side of the unit.
Locking the spotlight
To lock the spotlight in the on position, depress the On/Off trigger, then press the trigger lock bar. The spotlight will stay on until the trigger
unlock bar is pressed and the on/off trigger is released.
If the On/Off trigger is released when the trigger lock bar is pressed, the spotlight will be locked in the off position. To turn the spotlight on again,
press the trigger unlock bar before pressing the On/Off trigger.
4
Using the dimmer selectors
The up and down arrows adjust the light intensity. The down arrow dims the light. The up arrow brightens the light. A "beep"will sound when the
spotlight has been adjusted to its minimum (dimmest) and maximum (brightest) settings.
On a single charge, the spotlight will provide steady illumination for approximately 10 hours on its minimum (dimmest) setting; approximately
50 minutes on its maximum (brightest) setting.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use, we recommend that
the battery is charged at least every 120 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild
solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer to replace any
components that have become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Contact manufacturer for any information you may need.
SAFE BATTERY DISPOSAL
This unit contains a nickel metal hydride rechargeable battery pack, which must be disposed of properly when
it will no longer retain a charge. For information on recycling this battery, call toll-free (800) 822-8837.
To locate a free recycling program collection center near you, go to www.call2recycle.org.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
12 volt DC charger plug fuse replacement
The fuse in the plug end of the 12 volt DC charger protects the adapter' s charging circuit. If the 120 volt AC charger operates, but the DC charging adapter
does not, then this fuse may be opened (blown).
To replace the fuse:
1. Unscrew the end cap of the DC plug (counterclockwise).
2. Remove spring center contact and fuse.
3. Check fuse with a continuity checker.
4. If blown, locate a replacement 5 amp/250 volt fuse.
5. Replace the fuse, spring, contact and end cap.
6. Screw end cap clockwise until it is finger tight – DO NOT OVER-TIGHTEN.
7. Test for proper operation of the 12 Volt DC Charging Adapter.
TROUBLESHOOTING
The green battery status indicator LED does not light when charging
1. Check connection to the 12 volt DC charging port.
2. Check connection to AC or DC power source.
3. Confirm there is a functioning AC or DC current.
Unit will not operate
1. The spotlight will not operate when charging. Be sure all adapters are disconnected before spotlight use.
2. The battery may be completely discharged. Charge the unit following the directions.
3. If the spotlight does not operate after recharging as directed, contact manufacturer at (877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding
accessories, please contact manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
5
Publicidad
