Lelit William - PL71 Manual Del Usuario página 13

H.1 To enter in the programming mode and change the grinding time for 1 dose,
keep the switch (9) pressed until the led light (6) goes off, then release the switch.
From now and for 5 seconds the led light (6) stays off, the electronic card is in the
programming mode and the grinding time can be changed. In the same way, to
enter in the programming mode and change the grinding time for 2 doses, keep
the switch (12) pressed until the led light (6) goes off, then release the switch.
From now and for 5 seconds the led light (6) stays off, the electronic card is in the
programming mode and the grinding time can be changed.
H.2 To increase or diminish the grinding time, press either the switch "+" (12) or
the switch "-" (9). Each time you press it, you increase or diminish the grinding
time of half a second. This is visualized by the blinking of the led (6).
H.3 To exit from the programming mode, wait 5 seconds or, if you want to grind
your coffee immediately, press the grinding switch (7) (PUSH). Once the 5 seconds
are over, the led light (6) will blink for the new set time. Each blink corresponds to
a second and two quick blinks correspond to half a second.
I
Reset the factory parameters
I.1 To reset the electronic card, turn the grinder off. Once off, press both the
switches (9) and (12) contemporarily and then turn the grinder on pressing the
switch (5). The led light (6) shows that the reset has been completed blinking
quickly for 5 times.
J
Energy saving
J.1 When the grinder has not been used for 30 minutes, it goes in stand-by and
the led light (6) blinks every 3 seconds.
J2. To turn it back on, press any switch.
Note.
To remove the stand-by function, turn the grinder off. Keep the switch (4)
pressed and turn the grinder back on.
Lelit Espresso - English
EN
13