Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions - WP2550LBZ / WP8050LBZ
INSTALLATION
Tools Required
Torx T-20 screwdriver, 1/4" drill bit.
1.
Open the fixture by removing the six screws. (Figure 1.)
2.
Remove inner cover and set aside. Prepare the back
plate for mounting by drilling or knocking out the
appropriate holes. (Figure 2.)
3.
Line up the back plate in the desired location and
mount securely.
4.
If using electrical conduit, remove the screw cap from
the desired conduit hole and replace with conduit.
Route the branch circuit wires inside the fixture. If
using a junction box, bring the branch circuit wires
through the rear hole into the fixture.
5.
Splice the branch circuit power leads to the fixture
power leads: black to black (hot), white to white
(neutral), and green to green (ground).
6.
Reattach the inner cover to the back plate making sure
all wire connections are contained inside and no wires
are pinched. (Figure 3)
7 .
Replace the lens assembly using the six screws.
N
ote:
Mounting height to be a minimum of 6 feet.
Mounting
The back plate has a cast-in drill and knock-out template
to match any standard recessed junction box, three 5/16"
knock-outs for mounting hole and three 1/2" NPS tapped
holes for surface conduit or photocontrol unit.
A – 5/16" diameter Knockouts
B – 7/8" diameter Knockout
C – Knockouts for #10 screw
D – 1/2" NPS tapped holes
Important
To weather-proof your outdoor installation, use silicone
sealant to seal all holes in the fixture housing (mounting,
conduit, plugs, photocontrols, etc.) and all edges between
the fixture housing and the mounting surface.
2
EATON
IB514029EN
Installation instructions
Figure 1.
A
A
D
C
Figure 2.
Splice Cover
Figure 3.
A
D
B
D
Publicidad
