Installation And Starting Up; Placement Of The Hr6 Humidifier; Starting Up: Important Information - Wacota HR6 Manual De Uso

INSTALLATION AND STARTING UP

For the correct setup of your humidor with electronic humidifier (HR6) please read these
instructions carefully. It is fundamental for the correct conservation of your cigars with the best
humidity conditions: 70%.
Proceed to fill the tank with distilled water by removing the
cover of the left side of the humidifier, being careful not to get
water into the fan. Fill until the white mark inside the tank.
Placement - 1
Place the humidifier as close as possible to the back of the humidor.
Your humidor has a double back to allow the humidity to exit upwards by the upper part and
then descend to allow for circulation. The humidity reading is made at the upper part of the
device to maintain a constant humidity level in the whole area.

Starting up: important information

1. When plugged in to the power supply, the humidifier will begin to operate and will light the
green pilot, which will be turned off when the humidifier reaches humidity level set (70%).
When the red light turns on, it means that it is necessary to fill the tank with distilled water.
2. The digital humidity regulator of humidity is completely programmed to achieve the
necessary moisture of 70%. So, it is not necessary that set or change any setting of the
regulator settings that have already been configured. Otherwise, a malfunction may occur.
3. At the beginning and until the area is fully humidified, a lot of water will be consumed, which
is normal at this stage. After the humidity level is obtained, the consumption will drop.
10
Filling of the deposit
Placement - 2
Connection
Connect control
and net plug
to humidifier.
Placement - 3