Probe Connection - Omega HH-2000 Serie Manual Del Usuario

GB
Some of the options described may not apply to this
instrument. Please check the functions of the instrument
you have purchased before proceeding.
Model HH2001KC
Sensor
2-Input
SpeedRead
C/F
Hold
Range Lock
Max/Min
Logging
Model HH2001LTC
Sensor
2-Input
SpeedRead
C/F
Hold
Range Lock
Max/Min
Logging
2
X Instrument supplied pre-set to either °C or °F
Y Function available
Refer to rear of instrument for the temperature ranges.
INSTRUMENT OPERATION
BATTERIES
Two AA or equivalent cells (not supplied). Follow instructions on
reverse of instrument for fitting/replacement.
When
IP65/IP67 RATING
The waterproof rating for this product will not be maintained
unless the screws holding the battery compartment are firmly
tightened when inserting or replacing batteries.
ON - OFF
Press ON key for on and
after 12 minutes, unless any key is activated or the instrument is
in LOG MAX/MIN
on, automatic switch-off function will be disabled until the unit is
switched off.

PROBE CONNECTION

WARNING - Do not bring probe into contact with any service
connected to a hazardous voltage (i.e. a voltage exceeding 30
volts RMS or 42.4 volts peak with respect to either earth or
ground).
HH2001TC HH2002K HH2001P HH2001K
K T K PT100
Y
Y Y
X X Y Y
Y Y Y Y
Y
Y Y
HH2001PL HH2001KL HH2001A HH2002A HH2002AL
T PT100 K KTJNRS KTJRNS KTJRNS
Y
Y Y Y Y
X Y Y Y Y
Y Y Y Y Y
Y Y Y Y
Y Y Y Y
Y Y Y
symbol appears on display, replace batteries.
OFF key for off. Automatic switch-off
mode. If key is held when unit is switched
HH 2001P Wiring Diagram
Black
Black
K
Y
Y
Y
Red
Y
Red
Y
For 3 wire RTD probes - one Red wire
connects to both pins 2 and 4.
For 2 wire RTD probes - one Red wire
Y connects to both pins 2 and 4
and one Black wire connects to
Y
pins 1 and 3.
Y
Y
Y
Y
Y
pin 1 pin 3
TA 4F
(wiring side)
pin 4 pin 2
31