Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions TULOX 100 + TULOX 200
Version 2
If you wish to lead the cable through the axis, please follow the sequence described below.
1.
Screw the lock on tightly with 3 cylinder head screws M6 x 35 mm or BSW ¼" x 35 mm.
Consider the female thread of the bolt work. The insertion of the screws must be without
force.
2.
Insert the axis through the key hole into the lock case.
3.
Mark the axis for shortening approx. 9 to 10 mm in front of the external surface of the secure
storage unit door.
4.
Pull the axis out of the lock and shorten it at the marked point.
5.
Thread the cable into the axis (Figure 4).
6.
Slide the axis and the cable through the secure storage unit door into the lock case.
7.
Pull out the cable on the rear side of the lock case until the base plate lies on the secure stor-
age unit door. You need to insert the axis into the base plate to do this.
- 14 -
Steinbach & Vollmann Ibérica, S.L. • 20500 Arrasate - Mondragón • España
Axis
Keypad
Figure 4
Publicidad
