Safety Instructions - Bostitch F84-114 Manual De Operación Y De Mantenimiento

182223REVA_F84_Manual.qxp:180332REVA
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when loading, operating or servicing this tool. Eye protection is
required to guard against flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
CAUTION: Additional Safety Protection will be required in some environments. For example,
the working area may include exposure to noise level which can lead to hearing damage.
The employer and user must ensure that any necessary hearing protection is provided and
used by the operator and others in the work area. Some environments will require the use
of head protection equipment. When required, the employer and user must ensure that
head protection conforming to ANSI Z89.1 is used.
CAUTION: Replace worn or damaged parts immediately.
CAUTION: To avoid accidental injury, to yourself and others, bystanders must maintain a
CAUTION: The operator should always wear safety shoes.
CAUTION: Use only staples manufactured from Bostitch.
When loading tool: 1.) Never place a hand or any part of body in fastener discharge area of
tool.
Always handle the tool with care: 1.) Never engage in horseplay; 2.) Never actuate the tool
unless fastener discharge area of tool is directed toward the work; 3.) Keep others a safe
distance from the tool while tool is in operation as accidental actuation may occur, possibly
causing injury.
Keep hands and body away from the discharge area of the tool.
Do not drive fasteners on top of other fasteners.
This tool produces SPARKS during operation. NEVER use the tool near flammable
substances, gases or vapors including lacquer, paint, benzine, thinner, gasoline, adhesives,
mastics, glues or any other material that is - or the vapors, fumes or by-products of which
are -- flammable, combustible or explosive. Using the tool in any such environment could
cause an EXPLOSION resulting in personal injury or death to user and bystanders.
When working on tools note the warnings in this manual and use extra care when
evaluating problem tools.
7/30/08
safe distance from you, during use of this tool.
3
10:56 AM Page 3

SAFETY INSTRUCTIONS

LOADING TOOL
OPERATION
MAINTAINING THE TOOL