Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.9 Volume adjustment
• Press the UP (5) key to increase the volume.
• Press the DOWN (9) key to decrease the volume.
5.10 Brightness adjustment
• Press the LEFT (10) key to decrease the brightness.
• Press the RIGHT (8) key to increase the brightness.
5.11 Temperature Setting
The temperature reading from the temperature sensor (22) at the back of the Baby Unit will be displayed
on the top of the screen. To switch between °F (Fahrenheit) and °C (Celsius) follow the below instructions:
• Press the MENU/Exit key (12) and the menu screen will be displayed on the Parent Unit.
• Press the LEFT key (10) or RIGHT key (8) until the Temperature icon is highlighted in red then press
UP key (5) or DOWN key (9) to select between °F (Fahrenheit) or °C (Celsius) .
• Press OK (6) to confirm.
• Press the MENU/Exit key (12) to Exit.
Note 1: Temperature indicator will be displayed on top of the LCD screen.
Note 2: The temperature default setting is °C (Celsius).
Note 3: The monitor features a built-in automatic temperature alarm. The monitor will alert (visual
indication) when the temperature in baby's room is too
lower). This feature cannot be adjusted.
Note 4:
Make sure the temperature sensor is not positioned too close to the camera body as it may
affects the correct temperature reading. It is recommended to stretch out the sensor so it is as far away
from the camera body as possible. Also, it is recommended to place the camera in an area where there
is good air circulation and not in a closed cornered area where the temperature tends to be higher.
5.12 Lullaby Setting
You can soothe the baby to sleep by playing 4 pre-programmed lullabies from the Baby Unit. This
feature is controlled remotely from the Parent Unit.
• Press the MENU/Exit key (12) and the menu screen will be displayed on the Parent Unit.
• Press the LEFT key (10) or RIGHT key (8) until the Lullaby icon is highlighted in red then press
UP key (5) or DOWN key (9) to select the desired melody.
• Press OK (6) to confirm.
• Press the MENU/Exit key (12) to Exit.
• In order to stop the lullaby playback, go to the "Lullaby Setting" menu and select OFF icon.
Note 1: Once the lullaby function is turned on, the lullaby icon will be displayed on top of the LCD screen.
Note 2: The lullaby default setting is OFF.
5.13 Alarm Setting
You can use the alarm to remind yourself about: feeding baby / changing diaper / sleeping, etc.
• Press the MENU/Exit key (12) and the menu screen will be displayed on the Parent Unit.
• Press the LEFT key (10) or RIGHT key (8) until the alarm icon is highlighted in red then press
UP key (5) or DOWN key (9) to select the desired time interval (2H, 4H, 6H, OFF).
• Press OK (6) to confirm.
• Press the MENU/Exit key (12) to Exit.
Note 1: Once the alarm is activated, an alarm icon will be displayed on top of the LCD screen.
Note 2: The alarm default setting is OFF.
Note 3: If the alarm is not stopped manually, the ringing will last for 1 minute and then stop.
It will then ring again in 3 minutes. After 3 cycles, the alarm will be
automatically deactivated.
high
(32°C
and higher) or too low
EN
(13°C
and
6
Publicidad
Tabla de contenido
