Danfoss EKC 102D Manual Del Usuario página 5

Save the controllers present settings to the programming key. Select your own number.
Load a set of settings from the programming key (previously saved via o65 function)
Replace the controllers factory settings with the present settings
Select application for S5 sensor (0=defrost sensor, 1= product sensor, 2=condenser sensor with alarm)
Service
Temperature measured with S5 sensor
Status on DI1 input. on/1=closed
Status on night operation (on or off ) 1=closed
Read the present regulation reference
Status on relay for cooling (Can be controlled manually, but only when r12=-1)
Status on relay for fans (Can be controlled manually, but only when r12=-1)
Status on relay for defrost. (Can be controlled manually, but only when r12=-1)
Temperature measured with Sair sensor
Factory setting
If you need to return to the factory-set values, it can be done in this way:
- Cut out the supply voltage to the controller
- Keep upper and lower button depressed at the same time as you recon nect the supply voltage
Fault code display
E1 Fault in controller
E 27 S5 sensor error
E 29 Sair sensor error
EKC 102D
Alarm code display
A 1 High temperature alarm
A 2 Low temperature alarm
A 4 Door alarm
A 15 DI 1 alarm
A 45 Standby mode
A 59 Case cleaning
A 61 Condenser alarm
Instructions RI8KU567 © Danfoss 08/2010
o65 0 25
o66 0 25
o67 OFF On
o70 0 2
u09
u10
u13
u28
u58
u59
u60
u69
Status code display
S0 Regulating
S2 ON-time Compressor
S3 OFF-time Compressor
S4 Drip-off time
S10 Refrigeration stopped by main switch
S11 Refrigeration stopped by thermostat
S14 Defrost sequence. Defrosting
S15 Defrost sequence. Fan delay
S16 Refrigeration stopped because of open DI
input
S17 Door open (open DI input)
S20 Emergency cooling
S25 Manual control of outputs
S29 Case cleaning
S32 Delay of output at start-up
non The defrost temperature cannot be dis-
played. There is stop based on time
-d- Defrost in progress / First cooling after
defrost
PS Password required. Set password
0
0
OFF
0
5