Kit Assembly - Metra 99-7635 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the radio brackets to the radio
trim panel. The following step will
secure the brackets in place. (Figure A)
2. Attach the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips screws
provided. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, and then secure it using the
screws supplied with the radio.
(Figure C)

KIT ASSEMBLY

(Figure A)
(Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Secure the radio assembly to the dash
using the factory screws.
7. Reassemble the dash in reverse
order of disassembly to complete the
installation.
(Figure C)
REV. 2/28/2018 INST99-7635
5