Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Listening to your Device through the
Auxiliary Line-in Jack
1. Connect a 3.5mm audio cable (available at www.
xtrememac.com) to the headphone or line out jack
of an audio device and plug the other end of the
cable into the Aux jack on the back of the unit.
2. Press the Power button on the top of the unit or on
the remote to power on the Tango BLC.
3. Press the Source button on the unit until the Aux
indicator
4. Press Play on your device and use the control dial
on the unit to adjust the volume.
Adjusting Bass and Treble
While playing audio, press the Bass or Treble button
on the unit and use the Volume control to adjust the
setting. The LEDs on the unit will illuminate from the
center to indicate the level of bass and treble at +/- 4
for each setting. You may also adjust the bass and
treble with the remote.
LED indicators
SOURCE
The Source indicator will light when pressing the
Source button to indicate the selected source. Once
selected the indicator will remain lit.
VOLUME
The LEDs will illuminate in sequence when adjusting
the volume to indicate volume level. The LEDs for
volume will time out after 2 seconds and only the LED
for the source will remain illuminated.
BASS/TREBLE
The LEDs on the unit will illuminate from the center
to indicate the level of bass and treble at +/- 4 for
each setting. The LEDs for volume will time out after
2 seconds and only the LED for the source will remain
illuminated.
Troubleshooting Tips
No Power
Connect the AC adapter into the jack in the back of the
unit labeled "18V 2.5A" and then plug the AC adapter
into the wall outlet.
Check wall outlet function
Plug another device into the same outlet to confirm
the outlet is working.
Controlled material extracted from Matrix on Jul 1, 2013 04:12:00 AM CDT
lights.
11
Publicidad
Tabla de contenido
