Haldex CR Manual Del Usaurio

Type CR
Controlled
Response
Height Control
Valve
L31177 Rev. 2/10
Figure 1. Specification Diagram
BREAK OFF AT
INTAKE
LINE FOR SHORT
(UP)
ARM APPLICATION
EXHAUST
(DOWN)
EXHAUST
OUT To Air
Spring
IN From Air
Supply
Figure 2. Features of Type CR HCV
GENERAL INFORMATION
The Haldex Controlled Response (CR) Height Control Valve (HCV) automatically adds
air to, or exhausts air from air suspension to maintain a constant static design height.
The Type CR Height Control Valve does not respond to short duration dynamic changes
in axle position.
-- The Haldex Type CR HCV can be used for right hand or left hand and long or short
control arm applications. Refer to installation instructions herein for proper plumbing
connection.
-- All valve ports are 1/8" NPT.
-- Compression fittings for 1/4", 3/8" or metric tubing, or push-in fittings are available -
specify when ordering.
-- Optional dump functions are available using
Part No. 90554902 or Part No. 90554335.
-- Several different linkage assemblies can be
purchased. Contact your Haldex Distributor for details.
NOTE: The Haldex Type CR can be interchanged with
other brands of height control valves.
PRE-INSTALLATION INFORMATION
IMPORTANT: The Height Control Valve (HCV) and linkage are designed to maintain
the vehicle ride height as loads increase and decrease. Proper set up of the HCV(s) is
critical to the system performance. Prior to any assembly or disassembly, please read all
instructions. Should you feel unable to properly perform the installation and adjustments
of a Haldex Type CR HCV contact Haldex Technical Services or have a certified mechanic
install or adjust the valve.
CAUTION: Incorrect installation of valves and associated components can impair
suspension and vehicle performance. It is extremely important that the original equipment
manufacturer's specifications of a one- or two-HCV system are followed when installing
the air control system. Refer to vehicle and suspension manufacturer's instructions for
recommended valve location.
DO NOT install a single height control valve of any type if the suspension or vehicle
manufacturer specifies a two (2) height control valve system.
DO NOT use antifreeze or other solvents in air supply line. Use of
solvents or antifreeze can damage seals and voids the valve warranty.
ALWAYS use a Pressure Protection Valve (PPV) and filter such as the
Haldex Part Number 90554107. Attach PPV directly to the air reservoir
for supply to the Type CR HCV.
Figure 3. Block Height
1/4" Adjusting
Lock Nut
Locating Pin
Manufactured
Date Code
Figure 4. Jack Stand Height
Linkage
Block Height
Lower Bracket
Ride
Height
Type CR HCV
Ride
Height
Jack
Stand
Height