Visitor Rings The Doorbell - Marmitek DOORGUARD 470 Modo De Empleo

5 A VISITOR RINGS THE DOORBELL
In this example, 2 camera doorbells are connected.
Please refer to the left column if you only have 1 doorbell.
STANDBY mode
The visitor rings doorbell 1
For 5...30 seconds
you will hear a
melody, both inside
and outside.
(1 out of
16 selectable melodies)
The image of the visitor
will automatically appear
on the monitor.
Press the intercom button
(5).
The melody will stop.
You can now start a
conversation via
doorbell 1.
The conversation stops
automatically after 120
seconds.
Press the door opener
button (6) (or walk to the
door if it is not installed)
Both the image and the voice of the visitor remain active for 20
seconds when the door opener is operated. This enables you to
verify that the door opener has worked well.
If an SD card is installed in the monitor, a video recording will be
made each time the bell is rung.
14
The visitor rings doorbell 2
If both doorbell 1 and 2 are rang at the same time, the
doorbell that was pressed first will be connected to the
monitor. On the monitor, you will now hear 3 short
tones to indicate that the other doorbell was also
pressed.
If the camera of the outdoor unit is blocked, and you
do not see an image of the visitor, press the monitor
button to switch to a 2
button again to return to the image from the outdoor
unit.
The monitor will automatically enter standby mode
when the intercom button is not pressed within 60
seconds.
The door opener is
activated.
nd
camera. Press the monitor
Press the disconnect
button (7).
Standby
© MARMITEK