Required Cable Type - Marmitek DOORGUARD 470 Modo De Empleo

3.1

Required cable type

Please ensure that the power to the system is off during
installation.
To connect the camera doorbell to the monitor, you can use the supplied
4-wire cable.
Should you want to cross a longer distance, please refer to the following
table for the required type of cable:
Cable length
1-25m
25-50m
50-80m
80-100m
CAT5 or CAT6 network cable connections (not recommended)
Afscherming
You can use the two included additional connectors for this.
8
Required cable type
4-wire cable of minimum 4x 0.2mm
4-wire cable of minimum 4x 0.3mm
4-wire cable of minimum 4x 0.5mm
coaxial cable, 75 ohm of minimum 1.55mm
audio cable of 0.55mm
Unshielded cable (<25m)
Shielded cable (<80m)
Coaxial cable + 2-wire audio cable (<100m)
Unshielded network cable (<25m)
Shielded network cable (<50m)
2
, unshielded
2
, shielded
2
, shielded
2
2
+ 2-wire
Afscherming
© MARMITEK