Charging - Toa BC-5000-2 Instrucciones De Uso

5. CHARGING

CAUTION
Notes
• Use the charger in locations where ambient temperature ranges from 0 to 40ºC (32 to 104ºF).
• Be sure to charge the WB-2000 battery before use.
• Do not use the charger in locations subject to strong vibrations as poor electrical contact may result,
preventing correct charging.
• Do not frequently insert and remove the unit from the charger during charging as this could degrade the WB-
2000 battery performance.
• If the battery operating time is extremely short even when it has been fully charged, be sure to replace it with
a new WB-2000 as the battery has reached the end of its life.
Tip: Under normal use condition, the battery can cycle through about 500 charges and discharges, after
which it will usually need to be replaced.
1
AD-5000-2 AC Adapter
(option)
2
To AC wall outlet
Step 1. Connect the optional AC adapter to the charger.
After connection, fit the cord into the charger's bottom slot to prevent the AC adapter plug accidentally
slipping out of place.
Step 2. Connect the power cord to the AC adapter, then to an AC wall outlet.
Step 3. Set the charger's power switch to ON.
The power indicator will light.
When charging, never load rechargeable batteries other than the
specified WB-2000 battery in the unit to be charged. Charging any
other than the WB-2000 battery may result in fire or personal injury
due to battery rupture.
Power input terminal
Full-charge indicator
Power indicator
2
Power cord
(supplied with the AD-5000-2)
Mounting adapter
Charging
indicator
5
Charger
Handling the power cord
AC adapter plug
WM-5225 (optional)
or WM-5265 (optional)
4
Power switch
WM-5325 (optional)
or WT-5100 (optional)
3 , 6
Power switch
Cord
Bottom view of the charger
5