Low Flame Adjustment - Fulgor Milano F4GK241 Serie Instrucciones De Installación

EN

Low Flame Adjustment

DANGER
Lighting gas burners with a match is dangerous.
You should match light the cooktop burners only In an
emergency.
Light a match and hold the flame near the burner you
want to light. Wooden matches work best.
Push in and turn the control knob slowly. Be sure you are
turning the correct knob for the burner you are lighting.
NOTE: If the burner does not light within five seconds, turn
the knob off and wait one minute before trying
again.
WARNING
If you attempt to measure the inner cone of the flame,
please use caution.
Burns could result.
This appliance is shipped from the factory with low and
medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or two rings flame:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Insert a slender, thin-blade screwdriver into the recess
at centre of valve stem and engage blade with slot in
adjusting screw.
4. Turn center stem adjusting screw to set flame size:
• clockwise to reduce
• counterclockwise to increase
5. Replace control knob when adjustment is completed.
18
LOW FLAME ADJUSTMENT
ONE OR TWO RINGS FLAME
- Counterclockwise to increase flame size
- Clockwise to reduce flame size
Valve stem