Control Instructions For Use; Switching The Control On; Elements Setting; Using The Low Power Scale - Fulgor Milano F6RT24 Serie Manual De Uso & Mantenimiento

This touch control works using optical light sensing
after a power failure, any direct strong light over the
sensor area may affect the touch control functionality.
When powering on the unit make sure that no strong
light is shining direct over the touch control zone,
it can compromise the start-up sensor calibration
resulting in an unresponsive touch control.
When the cooktop is connected to the electrical voltage
supply all lights and digits turn on to indicate a proper
activation. This operation will be completed after few
seconds, the control turns off automatically. Now the
cooktop is ready for operations.
are locked (see that the lock led is on and turns off after
a few seconds).
single zone available for selection.
All the displays show power level "0", if no actions are
performed the control shuts down again after about 10
seconds.
desired zone: the HOT SURFACE (ref.3) indication
5b
2
Touch the slide bar to set the power level (levels 0 to
touching the desired value. If your cooktop model has
no slide bar.
10
WARNING
5a
4
1
3
The display (ref.4) and the "Peacock Tail" (ref.6) show
the power level, updated in real time.
After a 5 seconds time-out the value is accepted, the
steady. The "Peacock Tail" disappears after some
seconds more.
expires.
The following picture represents the Full Power Scale
whereas the control uses all the available power range,
from 0% up to the 100% corresponding to level 9.
Level 4 corresponds to 15% of the available power.
6
7
Figure. 7
Once a cooking zone has been selected, touch the
Power Scale (ref.9) then set the power level in the
usual way.
8
Figure. 8
Use & Care Manual
ENGLISH
9