Getting Started - Bellman & Symfon BE1510 Manual De Instrucciones

26
Bellman Visit 868 Repeater, BE1510
Introduction
Thank you for choosing products from Bellman & Symfon.
The Bellman Visit 868 System consists of a number of radio transmitters and receivers.
The transmitters detect different events in the surrounding area and transmit a radio
signal to the receivers. The receivers pick up this signal and provide indications using
light, sound and/or vibration.
The transmitter determines what type of light, sound or vibration should be displayed so
that the reason for the indication is evident.
Read through the entire user manual first and then start to install the system.
Refer to the illustration of the Bellman Visit 868 System on the inside of the cover.

Getting started

Unpacking, installing and testing the unit
1. Open the battery cover (7). Connect the power supply unit to the socket (6), fit one back-up
battery, either a 6LR61 alkaline or 6F22 lithium type battery, and close the battery cover.
2. Press the Test Button (2). The Bellman Visit 868 Repeater blinks with the LED (1) to indicate
that the unit is transmitting a radio signal. The Bellman Visit 868 receivers will indicate the Door
Signal.
3. Mount the Bellman Visit 868 Repeater on the wall either using the self-adhesive Velcro tape
or suspended on the wallmount bracket (8) on the screw supplied. If the Velcro tape is used, the
wall on which the transmitter is to be positioned can be cleaned using the enclosed wet wipe. The
Repeater can also be placed on a level surface, e.g. a table, but avoid placing it on the floor.
Function
General
The Bellman Visit 868 Repeater, BE1510, is a repeater in the Bellman Visit 868 System for
indoor use which receives a radio signal from a transmitter in the Bellman Visit 868 System and
transmits this radio signal to the receivers in the system. The aim is to increase the range and
obtain reception in locations in which it is not otherwise possible by using Bellman Visit 868
Repeaters.
The Repeater also operates as a multi-function transmitter, either via a pushbutton or via an input
for an Exterior External Trigger. The Test Button and Exterior External Trigger can be detected
separately and transmit different Signal Patterns to the receivers in the Bellman Visit 868 System
depending on what has activated the Bellman Visit 868 Repeater. There is a range of options
for connecting the Bellman Visit 868 Repeater to various applications. We recommend using a
maximum of one Repeater per system.
Radio key
On delivery all Bellman Visit 868 units are tuned to the same Radio Key. If you have a neighbour
with a similar system, you can change to different Radio Keys so that you do not affect each
other's systems. If you use the Radio Key Switch (5) to change the Radio Key on this transmitter,
you must also change all other units in your Bellman Visit 868 System to the same Radio Key.
Refer to the user manual for the relevant unit.
27
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
YU