Dynabrade 61300 Manual De Instrucciones página 5

CAUTION
Where it is critical to avoid shocks or sparks caused by static electricity, an electrically conductive and grounded air supply hose must be used.
WARNING
The following items should be well-noted for the effective use of the unit.
1. Always wear safety glasses and any other safety items
required by law.
2. The vacuum system will operate by an on/auto/manual switch
located on the front of the Motorhead/Vacuum Head Assembly.
This switch must be turned on to activate the Motorhead.
3. VACUUM SPEED CONTROL: Unit is equipped with a rheostat
motor control. Infinitely adjustable speed allows suction
regulation for wide range of tools. Note: For one tool, please
turn the vacuum speed control to 3/4 power.
MIN
SPEED CONTROL
D I S P O S A B L E B A G I N S TA L L AT I O N / R E M O V A L I N S T R U C T I O N S
When vacuuming dusts that are dangerous to health, with values of a maximum concentration in the work place,
or carcinogenic dust of groups I, II and III (e.g., asbestos), the waste dusts require special handling and disposal.
Disposal of hazardous material must conform with health and safety regulations.
Elbow
1
Installation
1. Insert and expand bag.
2. Place bag onto the elbow of the canister unit until rubber
gasket settles in grooved slot of elbow.
THIS IS A PRECISION PIECE OF EQUIPMENT designed for dust extraction to keep your ENVIRONMENT
"DUST-FREE." Read operating instructions before using Dynabrade Portable Vacuum System and be
thoroughly conversant with safety precautions in your locality.
G R O U N D I N G I N S T R U C T I O N S
Grounding by means of a ground wire between both ends of the air supply tubing
passing through vacuum hose is recommended.
O P E R AT I N G I N S T R U C T I O N S
Use 3/4 Power
Position for one
tool operation, full
power for two.
MAX
2
4. ELECTRONIC THERMAL PROTECTION DEVICE: Unit is
equipped with a overload prevention system. If this feature is
activated a 20 MINUTE COOL DOWN PERIOD inhibits use.
After a complete 20 minute cool down period has passed the
Electronic Thermal Protection Device will RE-SET automatically
and the unit will be on line ready for use.
5. VISUAL WARNING SIGNAL: Unit is equipped with a visual
warning (yellow) light to indicate when air flow falls below
standard. Turn off vacuum and replace disposable collection
bag. The warning signal will RE-SET automatically and the unit
will be ready for use.
*IMPORTANT NOTICE*
1. For "M" Class Dust Collection, you must use all three
filter elements (Paper Filter, Felt Insert, Disposable Bag).
2. Please inspect all filter elements regularly and replace when
necessary. Dust in the motor area will damage the motor
within a short time. Dust in the motor will Void Warranty.
Tab
3
Removal
3. Pull bag off and pull tab forward.
4. Push tab until it covers opening and locks with the
rubber gasket.
4
3